![]() ![]() The switch position of the tape reader was not AUTO (without reel) or REEL ON/REEL OFF (with reels).Ī unusable G code was commanded. Or two “-” signs were used).ĭecimal Point “.” Input error (A decimal point was input after a address with which it can’t be used. Sign “-” input error (sign “-” was input after a address with which it can’t be used. The address was not followed by the appropriate data but was followed by another address of EOB code This alarm will be generated only when the TV check is effectiveĭata exceeding the maximum allowable number of digits was inputĪ numeral or the sign (-) was input without an address at the beginning of the block TV Alarm (The number of characters in a block is odd). TH Alarm (A character with incorrect parity was input) Correct the tape Re-apply the power after the parameter has been input These codes cover everything from Incorrect parameters, through to servo, spindle alarms and system faults causing alarms. Hopefully here you will find the Fanuc 6 alarm code(s) presented on your display. Thanks for visting our Fanuc System 6 alarms page. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |